HP ProCurve 2610-PWR Management And Configuration Manual page 272

Port Trunking
Port Status and Configuration
LACP trunk status commands include:
Trunk Display Method
CLI
CLI
Port/Trunk Settings screen in menu interface
Thus, to display a listing of dynamic LACP trunk ports, you must use the show
lacp command.
N o t e
Dynamic LACP trunks operate only in the default VLAN (unless GVRP is
enabled and Forbid is used to prevent the trunked ports from joining the default
VLAN). Thus, if an LACP dynamic trunk forms using ports that are not in the
default VLAN, the trunk will automatically move to the default VLAN unless
GVRP operation is configured to prevent this from occurring. In some cases,
this can create a traffic loop in your network. For more on this topic, refer to
"VLANs and Dynamic LACP" on page 12-20.
In most cases, trunks configured for LACP operate as described in table 12-4
on the next page.
12-16
show lacp
command
show trunk
command
Static LACP Trunk Dynamic LACP Trunk
Included in listing. Included in listing.
Included in listing. Not included.
Included in listing. Not included