HP J3245A Installation And Configuration Manual page 46

Using the Console Interface
Screen Structure and Navigation
Table 2-1.
Task:
Execute an action from an
"Actions-[>] menu:
Reconfigure (edit) a parameter
setting or a field:
Exit from a read-only screen.
2-6
How To Navigate in the Console
Actions:
Use either of the following methods:
Use the arrow keys ( [<] , [>] , [v] , or [^] ) to
highlight the action you want to execute, then
press [Enter].
Press the key corresponding to the capital letter
in the action name. For example, in a configura-
tion menu, press [E] to begin editing parameter
values.
1. Select a configuration area, such as System. (See
figure 2-2.)
2. Press [E] (for Edit on the Actions line).
3. Use [Tab] or the arrow keys ([<], [>], [^], or [v]) to highlight
the item or field.
4. Do one of the following:
• If the parameter has preconfigured values, use the
Space bar to select a new option
• If there are no preconfigured values, type in a value.
5. If you want to change another parameter value, return to
step 3.
6. If you're finished editing parameters in the displayed
screen, press [Enter] and do one of the following:
• To save any configuration changes you have made (or
if you have made no changes), press [S] (for the Save
action).
• To exit from the screen without saving any changes
that you have made, press [C] (for Cancel).
Note: Some parameter changes are activated when you
execute Save, and it is therefore not necessary to reboot
the switch after making these changes. But if an asterisk
appears next to any menu item you reconfigure, it is
necessary to reboot the switch to implement the change.
In this case, rebooting should be done after you have
made all desired changes and then returned to the Main
Menu.
7. When you are finished editing parameters, return to the
Main Menu.
8. If necessary, reboot the switch by highlighting Reboot
Switch and pressing [Enter]. (Refer to the Note , above.)
Press [B] (for the Back action).