Be sure to thread the cables through the rear of the non-hot-plug expansion cage into the server.
Connect the cables to the SATA connectors 1-4 on the system board
9.
page 11).
Install the air baffle.
10.
Install the access panel (on page 22).
11.
Do one of the following:
12.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 20).
13.
Removable media devices
This section provides the following information and procedures:
•
Identifying guide screws (on page 58)
•
SATA optical drive option (on page 58)
•
USB tape drive option (on page 60)
•
Full-height tape drive option (on page 61)
("System board
components" on
Hardware options installation 57