Table of Contents
Advertisement
2 – Features of the CC-222@%^
1 – Introduction
When stopped, pressing this key
Tape RECORD key
;
enters recording standby mode.
PITCH CONTROL knob
z
which allows the tape speed (and therefore the pitch) to
be changed by ±10%.
This three-position switch allows
REV MODE switch
x
the choice of single-side (
playback and recording, or continuous (
only (not recording).
CD-TAPE CONT PLAY key
c
playback (alternating between disc and cassette) on and off.
CD TIMER (OFF/PLAY) switch
v
the CD timer option on or off. When this is in the
position, turning on the machine with a disc inserted
will automatically start playback.
Stops CD playback or disc recording.
CD STOP key
b
Starts CD playback or recording (from
CD PLAY key
n
record standby mode).
Rear panel
DIGITAL COA XIAL (INPUT and OUTPUT ) jacks
!
These RCA jacks input and output SPDIF digital audio
data to and from the disc recorder.
Digital audio data received can be at any sampling
frequency between 32kHz and 48kHz. The output is
always 44.1kHz.
DIGITAL OPTICAL (INPUT and OUTPUT) jacks
@
digital optical connectors input and output SPDIF digital
audio data to and from the disc recorder.
Digital audio data received can be at any sampling fre-
quency between 32kHz and 48kHz.
LINE OUTPUTS (L,R) / 1(CD), 2(TAPE/AUTO)
#
these connectors to connect the amplifier to the analog
outputs of the disc recorder (1) or the outputs of the cas-
sette deck (2).
RIA A PHONO INPUT (L , R) a nd G ND ter mina l
$
Use these connectors to connect a record deck to the
CC-222
IV. The destination of the signal is deter-
MK
mined by a menu item.
12
TASCAM CC-222
IV
MK
This is a centerdetented knob
) or bidirectional (
Ä
Ê
) playback
ä
Use this to turn continuous
Use this switch to turn
PLAY
These
Use
CD PAUSE key
m
recording (starts recording from record standby mode).
CD RECORD key
,
mode and performs manual track incrementing while
recording.
MONITOR ( TAPE,MIX,DISC) switch
.
)
selects the source for the headphone outputs as either the
cassette deck, the disc recorder, or a mixture of both.
PHONES jack and volume control
/
pair of stereo headphones to this 1/4" jack, and adjust
the level with the control.
Connect the earth (grounding) wire of the record deck to
the
terminal.
GND
NOTE
Do not connect a record deck to the
do not connect any other equipment to these jacks.
LINE INPUTS (L,R) / 1(CD), 2(TAPE)
%
nectors to connect signal sources to the analog inputs
of the disc recorder (1) or the inputs of the cassette deck
(2).
VOLTAGE SELECTOR switch
^
either
or
230 V
120 V
NOTE
The voltage selector is only available on units for North
American market.
Connects the power cable supplied.
AC IN jacks
&
Pauses or resumes CD playback or
Places the disc in record standby
This switch
Connect a standard
inputs and
L I NE
Use these con-
Switches the voltage to
.
Advertisement
Table of Contents
