Recording Operations; Dubbing Tapes From The Cd Deck - Tascam CC-222MKIV Owner's Manual

Cd recorder/cassette deck
Table of Contents

Advertisement

Recording operations

Recording pre-recorded tapes, records, or other pub-lished
or broadcast material may infringe copyright laws. Check
before recording.
1
Set the
switch.
REV MODE
If you want to make a bi-directional recording, set
the
switch to the
REV MODE
Set to the
position if recording is to be made on
Ä
a single side of the tape.
2 Load a recordable cassette. Check that the safety
tabs on the spine of the cassette are in place. If they
have been broken off, block the holes with adhesive
tape.
3 Press the
INPUT 2 SEL
as a recording source.
DISC
When
is selected, the built-in CD player's out-
DISC
put is selected as a source.
When
is selected, the external signal from the
LINE2
jacks is selected as a source.
LINE 2

Dubbing tapes from the CD deck

To record from the internal CD deck:
1 Prepare for recording as described above (load a
tape, set the REV MODE, etc.).
2 Load the source CD disc into the unit with the re-
corded side down.
3
Use the
key to set the dubbing volume to
MENU
to bypass the input level control (see "Bypass-
THRU
ing the input level for dubbing" on page 24).
If you want to adjust the input volume, set the
menu to
and use the left (tape)
DUB >VOL
ON
control to adjust the level of signals fed to the tape
from the CD player.
NOTE
If you want to record the tracks on the tape in a differ-
ent order from those on the disc, use the programmed
playback mode to rearrange the tracks (see "Program
playback" on page 17). Leave the disc in stop mode
when you have finished programming the order.
4 Press the
key.
DUB 2
If the tape is in stop mode,
beginning of the current side.
At the start of the tape, recording starts, but the CD
does not start playback for eight seconds. The
indicator flashes.
The CD starts playback after the eight seconds at
the start of the cassette. The
steadily.
If the tape is in record standby mode,
or
position.
Ë
ä
key to select either
or
LINE2
INPUT
the tape rewinds to the
DUB
,
indicator lights
DUB
2
recording
7 – Cassette operating
1 – Introduction
4 Press the
RECORD
standby mode and the indicators light up.
5 Play back the source, and adjust the recording level
using the tape deck's
the loudest sound makes the meters briefly reach
around the "0 dB" point for normal or high-position
tapes (recording is not possible with metal tapes).
6 Press either the
PAUSE
To stop recording temporarily, press the
key. To restart recording, press either the
key or
keys. If the
PLAY
tor is unlit is pressed, the recording direction will
reverse, and the
restart recording.
7 To stop recording, press the
starts immediately, and the CD starts playback im-
mediately. The
The dubbing stops when playback reaches the end of the
CD, or when the tape reaches the end of its run (one side in
the case of single-sided (
the
Ë
reverse mode), whichever comes first.
Note that if the tape is set to auto-reverse, and the last item
recorded on one side of a tape was not completely recorded
before the tape was reversed, that item will be automati-
cally repeated.
Also note that when the tape automatically reverses, eight
seconds are used as non-recorded time at the beginning
of the second side (the tape is in record mode, but the CD
does not play back), again to allow for leader tape at the
start of the cassette.
The dubbing process can also be stopped manually with
the
key of the cassette deck or the CD deck. All
STOP
other transport keys are disabled.
NOTE
Dubbing is not possible if a cassette is not loaded, or
a CD is not loaded. It is not possible if the cassette is
write-protected, or if the CD is a recordable disc which
does not currently have any material recorded on it.
It is also not possible to enter the dubbing mode if the
tape is not in stop or record standby mode, or if the CD
is not in stop or pause mode.
key. The deck enters record
level control so that
INPUT
or
key to start recording.
PLAY
PAUSE
key whose indica-
PLAY
key must be pressed again to
PLAY
key.
STOP
,
indicator lights.
DUB
2
) reverse mode, both sides in
Ä
TASCAM CC-222
MK
PAUSE
31
IV

Advertisement

Table of Contents
loading

Table of Contents