Appendix A - Event Log - GE NetworX NX-148E User Manual

VII.

APPENDIX A - EVENT LOG

NOTE: Your system may not have all of the features listed in this table.
DISPLAY
TXlobat Transmitter
Low Battery
ZN Lost Zone Lost
Duress Duress
Man Fire Manual Fire
Aux 2 Auxiliary 2
Panic
Panic
KP Tamper Keypad
Tamper
BoxTamp Box Tamper
AC Fail AC Fail
OverCur Over Current
Srn Tamp Siren Tamper
Tel Flt Telephone
Fault
Exp Trb Expansion
Trouble
Log Full Log Full
Open Open
Close Close
Exit Err Exit Error
Rec Close Recent Close
Autotest Auto Test
Start Prog
Start
Programming
End Prog End
Programming
Start Dnld Start Download Download session is started.
End Dnld End Download Download session is ended.
NX-148E LCD Keypad
DESCRIPTION
The transmitter has a low battery.
A wireless or multiplexed zone device is not
reporting to the control.
The control has been armed or disarmed with a
Duress code.
Keypad "Fire" has been activated.
Keypad "Medical" has been activated.
Keypad "Panic" has been activated.
The keypad tamper has been activated.
The box tamper circuit has been activated.
AC failure has been detected.
A short circuit of a power supply has occurred.
A siren or speaker tamper has been detected.
A telephone fault or tamper has been detected.
An expansion device or keypad is not reporting
to the control.
The event log is full. Old events will be pushed
out as new ones enter the log.
Reports user number, date, time and partition of
opening.
Reports user number, date, time and partition of
closing.
Entry/Exit zone was faulted at the instant the
exit delay expired.
An alarm occurred within 5 minutes after the
control was armed.
Sending a communicator test at a specified
interval.
Local programming is started.
Local programming is ended.
23