Reading The Event Log; Adjusting The View / Brightness Of The Lcd - GE NX-148E - Security NetworX LCD Keypad User Manual

READING THE EVENT LOG

The control panel has an event log that can be retrieved using a master code.
This log contains a listing of the events along with date, time, and partition where
the event occurred.
To view the log, press r
Step 1
for a code.
Step 2 Enter your master code. The LCD screen will now show the most
recent event.
To view the events from most recent to the oldest, press the – down
Step 3
scroll key.
To view the events from the oldest to the newest, press the • up scroll
Step 4
key. The display contains the following information.
º
Event
º
Date
(Month/Day)
This screen shows an opening of Partition 3 on September 25
user 75. The [r] shows that this event is not programmed to be reported to the
central monitoring station. Refer to Appendix A on page 25 for a list of possible log
messages.

ADJUSTING THE VIEW / BRIGHTNESS OF THE LCD

Enter r
Step 1
Step 2 Enter [master code]. The LCD will now prompt you to raise or lower the
view.
Step 3 Using the scroll keys to the right of the LCD, you can raise or lower the
viewing angle of the text.
Step 4 To advance to the Brightness option, press [r]. The LCD will prompt you
to brighten or dim the LCD lighting. Use the scroll keys again to adjust to
desired brightness.
Step 5 When completed, exit by pressing [r].
NX148E-CF
Open
9/25 17:57
ü
Time shown in
24 hour format
9 1 . The LCD Screen will prompt for a code.
9 0 . The LCD screen will prompt you
75
P3*
³
User or Zone ID
»
Indicates partition
and r indicates an
event not reported
th
at 5:27 p.m. by
17