Reading The Event Log; Table 5 Event Description - GE CS5500 Programming Manual

7 R
EADING THE EVENT LOG
The event log displays the details of all the events that occur from when you turn the
system on. A maximum of 512 events are held in the event log. For a list of all possible
events, see page 46.
To read the event log:
1. Press OK at the system prompt and enter your installer code.
2. Navigate with the
3. Scroll to Event Log and press OK.
4. The last event to be added to the log is shown. The > symbol indicates that the
message must be scrolled horizontally.
5. Press F3 to scroll to the right and view the rest of the event description. Table 5
explains each part of the event description.
Alarm 3
168 17:32 >
•
In this case, an alarm occurred in zone 168 in partition 3 at 17:32. No report
was sent to the central station. The event occurred on September 25. This is
the twenty-eighth event in the log.
6. Press the keys to scroll through the events in the log.
Event description
L1
L2
EventType
PN
PartitionName
Zone/User Name
UN/ZN
HH:MM
DD/MM
LOG
keys to Commands and press OK.
Press F3
Explanation
EventType PN PartitionName
Zone/User Name UN/ZN HH:MM DD/MM LOG
The type of event that occurred.
The number of the partition in which the event occurred.
The name of the partition in which the event occurred.
The zone name or user name.
The user number, zone number or device number.
The hour and the minute the event occurred.
The day and month the event occurred.
The position of the event in the event log.

Table 5 Event description

Alarm 3
25/9 028