Reset Function - GE NetworX NX-148E User Manual

PROMPT
Outputs used?
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
Master code?
Sched arm only?
Arm only?
Reserved
Output 4 ?
Output 3 ?
Output 2 ?
Output 1?
Step 4 NOTE: The LCD will now display all of the partitions to which this user
has access. If you wish to remove a partition, press the partition number
on the keypad, and the display will mark that partition with a (-) hyphen
indicating access has been removed. If you wish to re-establish user
access to the partition, press the partition number again.
Press r to save the data. The LCD will then prompt you for the next
Step 5
user code.
Step 6 If another user code needs to be programmed, return to Step 3. If not,
press # to exit this feature without saving the data.

RESET FUNCTION

This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers.
Step 1 Disarm the system if it is not already disarmed.
Step 2 Press r
7 . Resets have now been performed.
Step 3 If the keypad begins beeping, the reset did not execute properly. Enter
your code to silence the keypad. Wait a few minutes and repeat step 2
to attempt another reset. If the keypad still beeps after repeated
attempts, please contact your installer.
14
» DO NOT CHANGE THIS SEGMENT!
(These are for use by a professional installer only.)
0=No 1=Yes
Your keypress will apply to the user code you entered in
Step 3.
If these messages appear on the LCD screen, press the [r]
key until you return to the prompt for the user code or until
you exit this adjust mode.
NX-148E LCD Keypad