Programming For Entrance Gates And Garage Door Openers In Canada - Subaru Tribeca 2014 Owner's Manual

6-20
Interior equipment
1) Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the "training light" on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press and
release the HomeLink button that was
®
programmed in the section above. Press
and release the button a second time to
complete the programming procedure.
NOTE
Some garage door openers may re-
quire you to do the above procedure a
third time to complete the program-
ming.
4. The garage door opener should now
recognize the HomeLink Wireless Control
®
System and your garage door opener
should activate when the HomeLink
button is pressed.
& Programming for entrance
gates and garage door open-
ers in Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
2. Press and hold the two outside buttons
until the HomeLink indicator light begins
®
to flash (after 10 seconds). Release both
buttons.
NOTE
When reprogramming any of the
HomeLink buttons that are already
®
programmed for other devices, perform
the procedure in step 2.
®
3. Hold the end of the entrance gate's/
garage door opener's hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
the driver's sun visor, keeping the indica-
tor light in view.
4. Press and hold the desired HomeLink
button.
5. Press and release ("cycle") the hand-
held transmitter button every 2 seconds
until step 6 is complete.
6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door
buttons on
®
®