Seatbelt Warning Light And Chime; Door Open Warning Light - Subaru Tribeca 2014 Owner's Manual

Hide thumbs Also See for Tribeca 2014:
Table of Contents

Advertisement

3-10
Instruments and controls

: Door open warning light

If any lights do not illuminate, it indicates a
burned-out bulb or a malfunction of the
corresponding system.
Consult your authorized SUBARU dealer
for repair.
Seatbelt warning light
&
and chime
Your vehicle is equipped with a seatbelt
warning device at the driver's and front
passenger's seat.
With the ignition switch turned to the "ON"
position, this device reminds the driver
and front passenger to fasten their seat-
belts by illuminating the warning lights in
the locations indicated in the following
illustrations and sounding a chime.
Driver's warning light
Front passenger's warning light
! Operation
If the driver and/or front passenger have/
has not yet fastened the seatbelt(s) when
the ignition switch is turned to the "ON"
position, the seatbelt warning light(s) will
flash for 6 seconds, to warn that the
seatbelt(s) is/are unfastened. If the dri-
ver's seatbelt is not fastened, a chime will
also sound simultaneously.
NOTE
. If the driver's and/or front passen-
ger's seatbelt(s) is/are still not fastened
6 seconds later, the seatbelt warning
device operates as follows according
to the vehicle speed.
– At speeds lower than approxi-
mately 9 mph (15 km/h)
The warning light(s) for unfastened
seatbelt(s) will alternate between
steady illumination and flashing at
15-second intervals. The chime will
not sound.
– At speeds higher than approxi-
mately 9 mph (15 km/h)
The warning light(s) for unfastened
seatbelt(s) will alternate between
flashing and steady illumination at
15-second intervals and the chime
will sound while the warning light(s)
is/are flashing.
. It is possible to cancel the warning
operation that follows the 6-second
warning after turning ON the ignition
switch. When the ignition switch is

Advertisement

Table of Contents
loading

Table of Contents