Brother Internet Print Using Telnet To Configure The Print / Fax Server - Brother NC-8100h User Manual

Brother Internet Print
Using TELNET to Configure the Print / Fax
server
Skip this section if you used BRAdmin or a Web Browser to configure the
remote Print / Fax server.
As an alternative to BRAdmin, you can use the Print / Fax server remote console
to configure the Print / Fax server. The console can be accessed via TELNET.
When you access the Print / Fax server using these utilities, you will be asked for
a password. The default password is "access".
1. When you get the "Local>" prompt after connecting to the console, enter
the command:
SET POP3
where ipaddress is the IP address of your POP3 server (consult with your
network administrator if you do not know this address).
2. Enter the command:
SET POP3
SET POP3
where mailboxname is the name of the remote Print / Fax server mailbox
and emailpassword is the password associated with this mailbox.
Usually the mailbox name is the same as the first part of the E-mail
address that you defined previously (for example, usually if the E-mail
address is emailprinter@xyz.com, then the mailbox name is
emailprinter).
3. The Print / Fax server is set by default to poll the POP3 server every 10
minutes. If you wish to change this value, enter the command:
SET POP3
where rate is the polling rate in minutes.
Type EXIT to exit the console and save the changes. You have now
completed configuring the Print / Fax server.
CHAPTER 8 BIP INTERNET PRINTING INSTALLATION
ADDRESS ipaddress
NAME mailboxname
PASSWORD emailpassword
POLLING rate
8-6