Brother NC-8100h User Manual page 161

APPENDIX
TELNET
® ®
To connect to the Print / Fax server using TELNET on UNIX, Windows NT , or
most other TCP/IP systems, type: TELNET ipaddress at the command prompt of
the system prompt, where ipaddress is the IP address of the Print / Fax server.
When you are connected, push RETURN or ENTER to get the "#" prompt, enter
the password "access" (the password will not appear on the screen), and type
anything in response to the Enter Username> prompt. When you see the Local>
prompt, you are ready to enter commands.
Enter HELP at the command prompt for a list of supported commands.
BRCONFIG
Brother BRCONFIG utility runs on the DOS system prompt and is installed with
BRAdmin. To connect the Print / Fax server using the Brother BRCONFIG
NetWare utility, Choose the BRCONFIG utility from the Brother BRAdmin
utilities. If you have only one Print / Fax server, you will be immediately
connected to that server. If you have more than one Print / Fax server, you will be
given a list of available Print / Fax servers. Type the number of the Print / Fax
server to which you wish to connect. When you are connected, enter the
password "access" (the password will not appear on the screen) at the "#"
prompt, and type anything in response to the Enter Username> prompt. When
you get the Local> prompt, you are ready to enter commands. To use
BRCONFIG, a Novell Server (running the IPX protocol) is necessary and an
active connection must be made to the server.
Enter HELP at the command prompt for a list of supported commands.
A-2