Shifting The Range - Furuno FCV-1150 Operator's Manual

1. OPERATION
2. Rotate the RANGE control to select a
range. The default ranges are as shown
in the table.
Unit Basic Range No, Range
1
m 10
ft 30
fa 5
HR* 6
pb 6
5
m 150 300
ft 500 1000
fa 80 160
HR* 100 200
pb 100 200
* HR is Hiro, Japanese unit of depth mea-
surement.
3. Press the ENTER key.
Note 1: Basic ranges may be preset as de-
sired, on the Range menu.
Note 2: The range mode indication (AUTO or
MANUAL), which appears at the top-left cor-
ner, may be turned on or off with Header Info
in the Display menu.
Note 3: In the dual frequency display, the
range for the low and high frequencies can be
adjusted mutually or independently. Turn on
Split Range in the Range menu to enable in-
dependent adjustment.
2 3 4
20 40 80
60 120 250
10 20 40
12 25 50
12 25 50
6 7 8
500 1000
1600 3000
250 600
300 600
300 600
1.6

Shifting the Range

The basic range and range shifting functions
used together give you the means to select
the depth you can see on the screen. The ba-
sic range can be thought of as providing a
"window" into the water column and range
shifting as moving the "window" to the desired
depth.
Window can be
shifted up and
down to select
starting depth.
Note: This function is inoperative when the
Auto mode is active.
1. Press or
the Shift setting window.
2. Use or on the SHIFT key to select
the amount of shift desired.
3. Press the MENU/ESC key to close the
window, or wait six seconds to automati-
cally close it.
Note 1: The bottom echo may be lost if the
amount of shift is greater than actual depth.
Note 2: "Auto Shift," which can be turned on
from the Sounder menu, automatically shifts
the range to keep the bottom echo on the
screen.
Note 3: You can set the shift value for each
range independently, by turning on Free Shift
in the Sounder menu.
6
Display
on the SHIFT key to show