Honeywell ADEMCO LYNXRIEN-EA User Manual page 33

Begin Time (minute)
b : xx
[xx] = begin minute 0 to 59
[*] = continue
[#] = return to previous prompt
Begin Day
xx : bd
[xx] = begin day 01 to 17
[*] = continue
[#] = return to previous prompt
End Time (hour)
xx : AE
[xx] = end hour 00 to 12
[*] = continue
[#] = return to previous prompt
End Time (am/pm)
[0] = end time, am (A)
[1] = end time, pm (P)
[*] = continue
[#] = return to previous prompt
End Time (minute)
E : xx
[xx] = end minute 0 to 59
[*] = continue
[#] = return to previous prompt
End Day
xx : Ed
[xx] = end day 01 to 17
[*] = continue
[#] = return to previous prompt
Device Number
x : dn
Not used
[*] = continue
[#] = return to previous prompt
USER FUNCTIONS
Scheduling User Interface
•
If the value programmed in the Event Identifier is "3",
"4", or "5", and the current entry is completed, the
system will save all field data up to this field. The
system will beep four times and go back to the first field
(Schedule Number) with the schedule number
advanced.
•
If the value programmed in the Event Identifier is "1"
or "2", and the current entry is completed, the system
will advanced to the next programming field - End Time
(hour).
NOTE: See figure 2 for the definition of begin day entries.
•
The end hour is a two-digit entry. To enter the hour 3,
press "0" followed by "3".
•
The end hour "00" indicates this schedule does not have
a end time.
•
Press "0" to select AM or "1" to select PM.
NOTE: See figure 2 for the definition of end day entries.
•
If the event identifier is set to "2" upon completion of
this field, the current schedule data will be saved and
the system will go back to the next schedule number.
[*] will accept and save the entire schedule event. The
system will beep four times and go back to the beginning
of the programming field (Schedule Number) with the
schedule number advanced. If the current schedule
number is 8, the system will wrap around and set the
schedule number to 1.
NOTE: For X10 devices.
– 33 –