Delta 20-950 Instruction Manual page 10

13. Attach the levers (O) to the underside of the table. Place springs on screws. Turn screws into levers clockwise with
standard screwdriver (not supplied) (Fig. 11).
14. Pull spring-loaded detent pin (P) Fig. 13. Twist it 90 degrees and release so it is out of the way, as shown in
Fig. 14.
15. Carefully lift table (Q) Fig. 15A, still upside down, and slide it onto bushing (R).
16. Place flat washer onto the 12 mm socket head cap screw removed previously and finger tighten the screw into hole
(S) Fig. 15A. Carefully rotate table around right-side up, as shown in Fig. 15B.
17. Use the included 12 mm hex wrench (Fig. 15B) to fully tighten table to the knuckle.
RISK OF UNSAFE OPERATION AND PERSONAL INJURY. Do not leave the table unattended without
fully tighetening the 12 mm screw into place.
18. Re-engage the detent pin (P) Fig. 13.
O
Fig. 11
R
Fig. 15A
ATTACHINg THE HEADSTOCK TO THE COLUMN
RISK OF PERSONAL INJURY - The head-
stock is very heavy. Use two or more people to place the
headstock on the column.
Place the drill press head (K) Fig. 16A on the column as
far as it will go. Align the head (K) Fig. 15 with the table (L)
and the base (M). Tighten the two head-locking screws (N)
Fig. 16B with the 5 mm wrench supplied.
Fig. 16B
Fig. 13
S
Q
N
P
Fig. 15B
Fig. 16A
10
Fig. 14
K
L
M
P