Delta 36-540 Instruction Manual page 8

8. Assemble splitter (H) Fig. 11, to splitter support
bracket (B) as shown using 3/4 inch-long hex head
screw, external tooth washer, and flat washer (L).
9. Fasten splitter (H) Fig. 12, to splitter support bracket
using flat washer, external tooth lockwasher and wing
nut (M). NOTE: Before tightening wing nut (M) make cer-
tain there is at least a 1/8" gap between the bottom edge
of splitter (N) and top surface of table (P) and that pro-
trusions (K) Fig. 12, are inside the slot of splitter assem-
bly (H).
10. Using a straight edge, check to see if the splitter (H)
Fig. 12A, is aligned with the saw blade (R). If an adjust-
ment is necessary, the splitter (H) can be moved left or
right and rotated.
11. When you are certain the splitter is properly aligned
with the saw blade, tighten the two screws (C) Fig. 12B,
that fasten the splitter support bracket to the splitter
bracket and tighten screw (G) that fastens the splitter
bracket to the pivot rod.
Fig. 12A
MITER GAGE
The miter gage is shipped completely assembled and is
supplied with a T-slot miter gage bar (A) Fig. 13, that is
inserted into either one of the two T-slotted miter gage
grooves located in the table top, as shown. The T-slot
miter gage prevents the miter gage from falling when it is
extended out beyond the front of the table when cross-
cutting extra wide workpieces.
R
H
P
N
G
H
A
8
L
B
Fig. 11
K
M
Fig. 12
C
Fig. 12B
Fig. 13
H