Table of Contents
Advertisement
2.
Enter the IP address of the management station permitted to access the local management
services.
3.
Click the Save/Apply button to save the IP Address.
4.
Enable the Access Control Mode (shown in Figure 5-75).
Note:
If Enabled, the Router will permit access to local management services from IP addresses
contained in the Access Control List. If the Access Control mode is Disabled, the function will not
validate, and all IP addresses can access to local management services. The services are the
system applications listed in the Service Control List.
5.7.4.3. Passwords
Choose "Management" "Access Control" "Password", you can see the screen (shown in
Figure 5-77) which allows you to change the factory default password of the Router.
To change the password:
1.
Enter the Old Password in the text box.
2.
Enter the New Password and Confirm Password. The Confirm Password should be the
same as the New Password.
3.
Click the Save/Apply button to make your change take effect.
TD-W8910G
54M Wireless ADSL2+ Router User Guide
Figure 5-76
Figure 5-77
73
Advertisement
Table of Contents
