TP-Link TD-W8910G User Manual page 55

reboot the Router to get the automatically assigned default gateway.
Default Gateway IP address should be specified since MER Interface is selected when you select
the Enable automatic Assigned Default Gateway check box.
5.4.6.2. Static Route
Choose "Advanced Setup" "Routing" "Static Route". You can see the Static Route screen,
this screen allows you to configure the static routes (shown in Figure 5-35). A static route is a
pre-determined path that network information must travel to reach a specific host or network.
To add static routing entries:
1. Click the Add button (pop-up Figure 5-36), and you will see the screen below (shown in
Figure 5-36).
2. Enter the following data:
Destination Network Address: The Destination Network Address is the address of the
network or host that you want to assign to a static route.
Subnet Mask: The Subnet Mask determines which portion of an IP Address is the network
TD-W8910G 54M Wireless ADSL2+ Router User Guide
Figure 5-35
Figure 5-36
47