Maintenance - Dimplex EWM-COPPER Parts & Service Manual

MAINTENANCE

WARNING: Disconnect power before attempting any maintenance or cleaning to
reduce the risk of fire, electric shock or damage to persons.
LIGHT BULB REPLACEMENT
Allow at least 5 minutes for light bulbs to cool before touching bulbs to avoid
accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or
when the clarity and detail of the log exterior disappears. There are two bulbs
under the log set which generate the flames and embers.
TOOL REQUIREMENTS: Slot screw driver
HELPFUL HINTS
It is a good idea to replace all light bulbs at one time if they are close to the end of
their rated life. Group replacement will reduce the number of times you need to
open the unit to replace light bulbs.
LOWER LIGHT BULB REQUIREMENTS: Quantity of 3 – 35 Watt Clear Halogen
Lamps, 120 Volt, G9 base. DO NOT EXCEED 35 WATTS PER BULB.
BULB REPLACEMENT
FIGURE 2
FIGURE 3
1. Unplug the unit from the outlet.
2. Remove the two mounting screws from the
bottom front of the heater assembly.
(FIGURE 3)
3. Loosen but do not remove the four heater
and light assembly mounting screws
located on the bottom sides of the wall
mounted electric fireplace. (FIGURE 3)
4. Slide the heater and light assembly forward
to release it from the bottom of the wall
mounted electric fireplace (FIGURE 2).
5. Place heater and light assembly on a flat
surface and examine the bulbs to determine
which bulb(s) required replacement
6. Remove the burnt out bulb(s) by gently
pulling straight out of socket. If bulbs are
difficult to remove from socket move the
bulb from side to side while pulling being
careful not to damage the light socket.
7. Insert new bulb(s).
8. Install the heater and light assembly onto
the four mounting screws.
9. Slide the assembly backwards to lock it into
position.
10. Tighten the four heater and light assembly
mounting screws.
11. Install the two front mounting screws.
12. Plug in the wall mounted electric fireplace.
5