Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dimplex SAHARA FIREPLACE 6903950000
Summary of Contents for Dimplex SAHARA FIREPLACE 6903950000
- Page 1 PRACTICAL USER’S GUIDE FOR THE SAHARA FIREPLACE Model 6903950000 series CAT NUMBER: EWF-SS Quality checked by: Valued Customer, We are pleased that you have chosen to purchase an electric fireplace manufactured by Dimplex North America Limited. 7208570100R04...
- Page 2 PAGE 1 Important Instructions PAGE 4 Fireplace Installation PAGE 8 Operation PAGE 10 Remote Operation PAGE 11 Maintenance PAGE 13 Warranty...
- Page 3 Rating Label Serial Number Label Serial NumberLabel Rating Label 4. If you have any questions or concerns regarding the operation of your fireplace, contact Dimplex customer service at 1- 888-DIMPLEX (1-888-346-7539).
- Page 4 IMPORTANT INSTRUCTIONS RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using the Sahara fireplace. 2.
- Page 5 8. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 9. To disconnect the unit, turn the controls off, then remove the plug from the outlet.
- Page 6 19. Disconnect all power supply before performing any cleaning, maintenance or relocation of the unit. 20. When transporting or storing the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage 21 If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a...
- Page 7 To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician. WARNING The supplied mounting bracket is designed for use with Dimplex wall mounted fireplaces only. Improper use, or use for purposes other than intended, may cause damage or injury. SAHARA FIREPLACE...
- Page 8 Figure 1 NOTE: It is recommended that the bottom of the unit not be mounted higher than 40" from the ground (mounting bracket no higher than 62"). WARNING Ensure the front of the installed unit will be at least 3 feet (0.9m) from combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains.
- Page 9 5. Adjust the wall-mounting bracket so the bubble on the level is centered between the two black lines. 6. Mark 5 other mounting screw locations, on the wall, ensuring that the wall bracket stays level. 7. Install the supplied wall anchors on the marked locations by placing a #2 phillips screwdriver into the recess of the anchor.
- Page 10 Figure 5 12. Mount the unit on the wall as shown (Figure 6). Wall Bracket Supports Wall Bracket Figure 6 13. Fix the unit in place by inserting 2 screws through 2 of the 4 available back panel holes, and into the wall studs. If studs are unattainable please use wall anchors.
- Page 11 OPERATION The controls are located on the bottom surface of the Sahara fireplace on the right side. Front View Figure 8 Bottom View A. MAIN ON/OFF SWITCH The switch has two ON positions marked with and “Manual”. The “Manual” position is for manual operation. In this position the built-in remote control is by-passed.
- Page 12 It can be reset by switching the MAIN ON/OFF SWITCH to OFF and waiting 5 minutes before switching the unit back on. CAUTION If you need to continuously reset the heater, unplug the unit and call Dimplex customer service at 1-888- DIMPLEX (1-888-346-7539).
-
Page 13: Remote Operation
REMOTE OPERATION The Fireplace is supplied with an integrated on/off remote control Note: Ensure that the fireplace 3 position switch is set to the remote Control setting. (Up position) To operate, push the ON button to turn fireplace on, push the OFF button to turn the fireplace off. BATTERY REPLACEMENT To replace the battery, slide battery cover open on the hand held transmitter. - Page 14 MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. LIGHT BULB REPLACEMENT Allow at least 5 minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin. Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears.
- Page 15 BULB REPLACEMENT INSTRUCTIONS: 1. Unplug the unit from the outlet. 2. Remove glass assembly as shown in figure 5. 3. Reach in and turn the burnt-out bulb(s) (or all bulbs) counter-clockwise to remove. 4. Replace with new bulbs. 5. Fit glass assembly back in place. 6.
- Page 16 Dimplex warrants such products to be free from defects in material and workmanship for a period of 2 years...
- Page 17 Dimplex warrants such products to be free from defects in material and workmanship for a period of 1 year from the date of first purchase of such products.
- Page 18 Dimplex will in its sole discretion either repair or replace such defective product or part without charge. If Dimplex is unable to repair or replace such product or part, or if repair or replacement is not commercially practicable or cannot be timely...
- Page 19 Such costs shall be the purchaser’s responsibility. What Dimplex and its dealers and service agents are also not responsible for: IN NO EVENT WILL DIMPLEX, OR ITS DIRECTORS,...
- Page 20 1-888-DIMPLEX 1-888-346-7539 1367 Industrial Road Cambridge, Ontario Canada, N1R 7G8 Approved for use in the United States and Canada...