Xerox 6030 User Manual page 63

TCP/IP
The following communication parameters need to be set up.
Default Parser
Physical Layer
(Ethernet Setting)
IP Address
MASK Value
E-Net Address
Dynamic Routing
Static Routing
The routing table can be edited if [Static Routing] is set to [ON].
ROUTING TABLE
Dest. Address
Router Address
Menu Item
Selects the parser or data format interpreter that is to be
used for processing when the input data format has not
been specified from [HPGL], [Versatec], [TIFF] and
[CALS]. The default setting is [HPGL].
Selects the physical layer. The default setting is
[AUTO].
[AUTO]
[10BASE_T]
[100BASE_TX] Fixed at 100BASE_TX
Enters the IP address in the XXX.XXX.XXX.XXX
format.
Enters the sub-net mask in the XXX.XXX.XXX.XXX
format.
Displays the Ethernet address. The value displayed is
unique for the hardware and cannot be changed.
Sets whether dynamic routing is to be enabled or not.
Sets whether routing is to be enabled or not. Set to
[ON] when you need to view the device through a
gateway or router.
A maximum of 512 items can be registered in the routing table. The [Registration Not
Possible] screen will be displayed if the number of items exceeds 512.
A Gateway must be setup by placing an entry in the Static Routing table.
Menu Item
Select [ADD] to enter additional routing information.
Sets the network address for the destination.
Enters in the XXX.XXX.XXX.XXX format. Typically
not needed.
Sets the router address for the local machine or subnet.
Enters in the XXX.XXX.XXX.XXX format.
The router address is also know as the Gateway
address.
Description
Automatic recognition
Fixed at 10BASE_T
Description
3.1 Setting up Communication Parameters
39