Hunter ceiling fan Instructions Manual page 17

Troubleshooting
Fan doesn't work
• Make sure power switch is on.
• Pull the pull chain to make sure
it is on.
• Push the motor reversing switch
firmly left or right to ensure that
it is engaged.
• Check the circuit breaker to
ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 9.
• Check the plug connection in
the switch housing.
Excessive wobbling
• Make sure the blades are
properly installed on the
blade iron posts.
• Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
• Use the provided balancing
kit and instructions to balance
the fan.
Remote control of fan is erratic
• Make sure the battery is
installed correctly.
• Install a fresh battery.
Transmitter only works when
held at close range
• Change battery.
M0097-01 • 04/14/14 • © Hunter Fan Company
Noisy Operation
• Make sure the blades are
properly installed on the
blade iron posts.
• Check to see if any of the
blades are cracked. If so, replace
all of the blades.
If you have multiple remotes or
multiple remote-controlled fans
installed on the same circuit
breaker and you are experiencing
interference or faulty operation of
your remote controls, please go to
www.HunterFan.com/FAQs
and click "How do I properly install
multiple remote-controlled fans?"
for information on how to correct
this issue.
17
www.HunterFan.com
1.888.830.1326
CFL bulbs flicker
• Turn the light switch off
and back on. Within three
minutes, hold down the Fan
Off button while pressing
the Light Off button twice. If
the problem is not corrected,
repeat the process up to
three times.