Hunter ceiling fan Instructions Manual page 12

Light Kit Light Kit
Switch
Housing
Screw
Partially install two of the switch housing
screws found in the
the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs and click
"How do I install my fan without the light kit?"
Switch
Housing
Screw
Align the notches in the sides of the lower
bag. Connect switch housing with the upper switch
housing screws. Lift the lower switch housing.
Twist the lower switch housing clockwise
to lock into place. Then thread the fan
pull chain through the hole in the light kit.
M0097-01 • 04/14/14 • © Hunter Fan Company
Notch
12
www.HunterFan.com
Install the third switch housing screw.
Tighten all three screws securely.
Make sure the lower switch housing is securely attached to
the upper switch housing. Failure to properly secure all three
switch housing screws could result in the light fixture falling.
1.888.830.1326