Parts And Functions - Haier HPU-18C03/NAF Operation Manual

Parts and Functions

Indoor Unit
FRONT OUTLET
CONTROL PANEL
FRONT BOARD
LEFT&RIGHT INLET
(AIR FILTER AND PROTECTING
WIRE NET INSIDE)
LOWER INLET
(AIR FILTER AND PROTECTING
WIRE NET INSIDE)
Display Board
TIMER ON/OFF
display
FAN SPEED display
Sleep
display
POWER/QUIET
display
NEGATIVE ION
display
Loading of the battery
Loading the batteries as illustrated. 2 R-03 batteries, resetting key(cylinder)
Remove the batteries in case that unit
Note:
won't be in usage for a long period.
If there are any display after taking-out
just need to press reset key.
Outdoor Unit
5
1
4
3
2
MODE
MODE
INLET
DRAIN HOSE
OUTLET
CONNECTING PIPING
AND ELECTRICAL WIRING
INLET
Dehu display
COOL display
Fuzz display
FAN display
AMBIENT TEMP
HEAT display
&SET TEMP display
Remove the battery cover;
Load the battery:
Be sure that the loading is in
line with the "+/-"pole request
as illustrated.
Put on the cover again
Confirm indicator
In disorderation, Reload the
batteries or load the new
batteries after 6 mins.
Remote controller
Remote controller Display
COOL display
MODE display
Signal sending
display
SWING display
FAN SPEED display
QUIET display
TIMER ON display&
TIMER OFF display
&SLEEP display
NOTE: The unexplained buttons and displays is not available for the unit.
The HEAT operation is not available for the unit COOL only you bought
Remote controller's operation
When in use, put the signal transmission head directly to the
receiver hole on the indoor unit.
The distance between the signal transmission head and the
receiver hole should be within 7m without any obstacle as well
Don't throw or knock the remote controlle
When electronic-started type fluorescent lamp or change-over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbedin receiving the signals,
so the distance to the indoor unit should be shorte
Use two same typed batteries when loading.
If the remote controller can't run normally during
operation, please remove the batteries and reload several
NOTE
minutes later.
False or unclear display during operation indicates
the batteries have been used up. please change batteries.
The waste battery should be disposed properly.
QUIET button
COOL button
AUTO button
FAN SPEED button
TIMER button
HEALTH button
LOCK button
LIGHT button
POWER ON/OFF button
DRY button
TEMP button
SWING button
HOUR button
EXTRA FUNCTION button
CONFIRM/CANCEL button
RESET button
DRY display
FAN display
HEAT display
TEMP display
POWER display
Negative Ion display
r.
r.
1