Moving The Heater; Maintenance - Master BLP 100 E Owner's Manual

MOVING THE HEATER

6

MAINTENANCE

WARNING: During proper heater work, the
control lamp of the reset button can blink for
short periods for regular intersals: this doesn't
represent a malfunction warning.
While in case of heater "block", instead, the
warning lamp will remain on and it will periodi-
cally blink.
M" models.
Flame monitoring is achieved via a thermal sensor which will cut off
gas supply in case of bad combustion or flame blame out.
"E" and "M" models are fitted with an overheat thermostatic cut off
device which will cut off gas supply in case of overheating. This safe-
ty device will automatically return to its initial function as soon as the
heater is cooled off. For that reason it is essential to locate and
repair properly the defect which has led to overheat before making
any attempt to re-start the heater.
To re-start the heater, follow instructions as indicated above.
MOVING THE HEATER
The space heater is equipped with handle and can be moved by
pulling it up and rolling it on its wheels.
MAINTENANCE
Before doing any maintenance, always stop and disconnect heater
from mains and gas cylinder. Wait till heater is cooled off. The fan
blades should be cleaned regularly. Clean also burner after having
removed combustion chamber and burner. All cleanings must be
made exclusively with compressed air.
WARNING: Avoid to direct compressed-air jet
in proximity to the micro-switch: it could be
irrecoverably damaged.
GB