Table of Contents
Advertisement
4.
The printer will beep twice, then release the FEED (
LCD indicates the desired function; "Calibrate" or "Self-test" or "Initialize".
Power ON Utilities
Standard Panel
LCD
Release FEED
button
for
different functions
Turn the printer OFF/ON to exit utility mode.
Self-test
The printer will print the printer configuration after
test printout can be used to check if there is any print head dot damage, printer
configurations and available memory space.
LCD Configurations
Calibrate.....
(5 dots)
Media sensor
calibration
calibration, self- test
Printer model name & Main board firmware version
Printer serial number
Printed mileage
Main board firmware checksum
}
Serial port setting
Code page
Country code
Print speed
Print darkness
Label size (width, height)
Gap/Black mark (vertical gap, offset)
Sensor sensitivity
Battery voltage
Print head temperature
Print head average resistance Bad dots of print head
Bad print head dots
}
Bluetooth settings information
}
WiFi settings information
}
File management information
Print head test pattern
~ 31 ~
) button when the
Self Test.....
(5 dots)
Media sensor
Printer initialization
and enter DUMP
Mode
media sensor calibration. Self-
Initialize.....
(5 dots)
Advertisement
Table of Contents
