Gap/Black Mark Calibration, Self-Test And Dump Mode - AMT Datasouth Fastmark M5e User Manual

Gap/Black Mark calibration, Self-test and Dump mode

While calibrate the gap/black mark sensor, the printer will measure the label
length, print the internal configuration (self-test) on label and then enter the dump
mode. To calibrate gap or black mark sensor, depends on the sensor setting in
the last print job.
1.
Turn OFF the power switch
2.
Hold on the button then turn on the power switch
3.
Release the button when the LED becomes
amber will do during the 5 blinks)
 The LED color will change in the following order:

Green

(5 blinks)
4.
The sensor will calibrate, the label length is measured and then the unit
prints the internal settings. Afterwards the unit enters the dump mode.
Note:
Please select gap or black mark sensor using Diagnostic Tool or by
GAP or BLINE command prior to calibrate the sensor.

amber red (5 blinks)

red/amber (5 blinks)
Release button
- 29 -
amber and blinking. (Any
 
amber (5 blinks)
solid green

green (5 blinks) green/amber