Table of Contents
Advertisement
Service settings via software
Submenu
This menu item lets you define the needle position on stopping.
The position is given in degrees. The needle position at top dead centre is
0°. The other handwheel positions are derived from this. 360° is a com-
plete turn of the handwheel.
Figure 52: Parameters in the submenu Stop Positions
Parameters in the submenu
Stop
Positions
Icon Entry
Submenu
In this submenu you can define settings for sewing foot lifting.
Figure 53: Parameters in the submenu Foot
Parameters in the submenu
Foot
Icon Entry
Service Instructions 650-16 Version 00.0 - Last Updated 09/2012
Stop Positions
Meaning
StopIdle°
Handwheel setting after thread trimming and
turning back
StopTop°
Handwheel setting for top stop position of
the needle on stopping in the seam
StopBottom° Handwheel setting for bottom stop position of
the needle on stopping in the seam
Foot
Meaning
FL AtStop Foot lifting on stop during sew-
ing
Sewing foot lifting after thread
FL After-
trimming
Trim
FL height Height of lifted foot
35
0
130
Stop Positions
0
0
30
Foot
Permissible value range
0 = No sewing foot lifting
1 = Sewing foot lifting
0 = No sewing foot lifting
1 = Sewing foot lifting
0 – 999
Permissible
Default
value range
value
0° – 359°
35°
0° – 15°
0°
0° – 359°
130°
Default
value
0
0
30
61
Advertisement
Table of Contents
