Duerkopp Adler 650-16 Service Instructions Manual page 19

Adjusting the lightbeam sensor disk
Figure 9: Adjusting the lightbeam sensor disk
(1) - Grub screws
Adjusting steps
1. Lock the machine in Position 6 ( p. 15).
2. Remove both grub screws (1) on the sensor disk.
3. Turn the sensor disk so that the 180° disk (3) points to the front and its
4. Tighten both grub screws (1) without changing the position of the sensor
5. Release the lock ( p. 15).
Service Instructions 650-16 Version 00.0 - Last Updated 09/2012
lower edge is precisely lined up with the lightbeam slot (2).
Important: The sensor disk must be aligned laterally so that the 180°
disk (3) does not touch the lightbeam housing.
disk.
(2) - Lightbeam slots
(3) - 180° disk
17