Error Messages; General Error Messages - Cisco Aironet Installation And Configuration Manual

Chapter 9 Troubleshooting

Error Messages

This section provides a list of error messages that may appear during the installation, configuration, or
use of your client adapter. The error messages are divided into four sections (general, LEAP
authentication, PEAP authentication, and EAP-SIM authentication). The messages are listed in
alphabetical order within each section, and an explanation as well as a recommended user action are
provided for each message.
Table 9-3
Error Message Category
General
LEAP authentication
PEAP authentication
EAP-SIM authentication

General Error Messages

This section lists general error messages that may appear at any time and are not related to authentication
attempts.
Error Message Bad Firmware Image File (filename)
Explanation
Recommended Action
Error Message Card Removed at xx:xx
Explanation
Recommended Action
Error Message Error Reading filename
Explanation
Recommended Action
try to load it again or select a different firmware file and try to load it.
OL-1394-04
Table 9-3
Locating Error Messages
Page Number
9-9
9-12
9-15
9-20
The selected firmware file is corrupt and will not be sent to the client adapter.
Select a different firmware file and try to load it.
The client adapter was ejected from the computer.
Reinsert the client adapter if you wish to resume wireless communications.
A problem occurred while the computer was reading the firmware file from the disk.
Re-copy the firmware file to a floppy disk or to your computer's hard drive and
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
enables you to quickly locate the error messages you need.

Error Messages

9-9