Icom IC-F9011B Instruction Manual page 14

2
PANEL DESCRIPTION
PRIO A REWRITE AND PRIO B REWRITE KEYS
"PRAR" "PRBR"
❍ For Simple/10-key types
➥ Push to select Priority A or Priority B channel.
➥ Push and hold [Prio A (Rewrite)] or [Prio B (Rewrite)] for
1 sec. to rewrite the operating channel as the Priority A or
Priority B channel.
❍ For Non-display type
Push to select Priority A or Priority B channel.
COMPANDER KEY "COMP"
The compander function reduces noise components from
the transmitted audio to provide clear communication.
❍ For Simple/10-key types
Push to toggle the compander function ON and OFF.
❍ For Non-display type
➥ Push and hold for 1 sec. to turn the compander function ON.
➥ When the compander function is ON, push to turn the
function OFF.
OPT OUT KEYS "OP1" "OP2" "OP3"
❍ For Simple/10-key types
Push to control the output signal level from the optional unit
connector.
❍ For Non-display type
➥ Push and hold for 1 sec. to control the output signal level
from the optional unit connector.
➥ When this key function is activated, push to deactivate
the function.
9
D For Simple/10-key types only
Following key functions cannot be programmed to Non-dis-
play types.
CH UP AND DOWN KEYS "UP" "DOWN"
➥ Push to select an operating channel. When [Rotary selec-
tor] selection mode is "operating channel," this function is
not available.
➥ Push to select a scan group after pushing and holding
[Scan].
ZONE KEY "ZONE"
Push this key, then push [CH Up] or [CH Down] to select the
desired zone.
When [Rotary selector] selects "operating zone," push this
key to switch the range of selectable zones.
What is "zone"?— Selected channels are assigned to a zone
according to how they are to be used in a group. For example,
'Staff A' and 'Staff B' are assigned into a "Business" zone, and
'John' and 'Cindy' are assigned into a "Private" zone.
USER SET MODE KEY "SET"
➥ Push and hold for 1 sec. to enter user set mode.
• During in the user set mode, push this key to select an item that
is enabled by your dealer, and change the value or condition by
pushing [CH Up] or [CH Down].
➥ Push and hold this key for 1 sec. again to exit user set mode.
User set mode is also available via the 'Power ON func-
tion.' Refer to p. 14 also.