Table of Contents
Advertisement
Adding Paper Sources
Adding Paper
Sources
3-8
The procedure below applies to the 10BASE-2 port.
To make the connection, firmly plug the cable connector into the
Ethernet interface port on the back right of the printer. Secure the
connector by turning the connector hood. Plug the other connector
into a networks Ethernet port. Consult your computer
documentation if you need help.
Selecting the Ethernet Interface
The printer' s standard interfaces are parallel and serial. While the
Ethernet interface board is installed, the printer automatically detects
that the computer is using the Ethernet interface.
Ethernet Specifications
The table below shows the physical specifications of the Ethernet
interface.
Specification
The span of l0BASE-2
The span of l0BASE-T
Speed of data transmission
Paper Feeder
If you switch paper sizes frequently, you may want to add a second
paper source. Or you may simply wait to increase the paper capacity
of your printer. You can easily do this by installing an optional paper
feeder which consists of a base frame and a paper tray. The paper tray
in the paper feeder is identified as tray 2 and the one in the basic
configuration is identified as tray 1.
The paper types and sizes used by tray 2 are the same as those for the
standard paper tray. The capacity is 500 sheets of 0.09 mm thick
paper, twice that of the standard paper tray.
Description
Max. 185 meters
(coaxial, bus connection)
Max. 100 meters
(twisted-pair, star connection)
10M bits/second
User' s Manual
Advertisement
Table of Contents
