Table of Contents
Advertisement
Periodic Routine Maintenance
4-12
Installing the New Print Unit
Notice:
To avoid exposing the photoconductor drum to light or
contamination, follow these guidelines:
Do not remove the print unit from its envelope until you are ready
l
to install it.
Complete the procedure as quickly as possible to avoid exposing
l
the drum to light for more than three minutes.
To avoid damaging the drum:
Be
sure to remove the plastic sheets after installing the print unit.
l
Operating the printer without removing the sheets will make the
print unit unusable.
Never touch or scratch the green drum surface.
l
Print unit
Green d
Be
careful not to allow dust or foreign matters into the toner
l
hopper.
To install the new print unit, follow these steps:
Remove the print unit
1.
from its envelope.
unit on a level, steady place.
2.
Remove the protective
materials from the print
protective
unit. Remove
sheet 1 Pull narrow clear
tape 2 until its blue end is
visible and remove it.
User' s Manual
Place the
Advertisement
Table of Contents
