Wan Service - TP-Link TD-W8968 User Manual

TD-W8968
Note:
Enabling packet level QoS for PVC improves performance for selected classes of applications.
While QoS consumes system resources; therefore the number of PVC(s) will be reduced. Besides
this, it cannot be set for the connection type of CBR and Real-time VBR. If you select the QoS
service, the Quality of Service menu will be added to the Web-based Utility, the detailed
configuration will be described in
4.4.1.2 ETH Interface
If your modem router works on Wireless Router Mode, choose "Advanced Setup" "Layer2
Interface ETH Interface", you can see ETH WAN interface on the screen below.

4.4.2 WAN Service

Choose "Advanced Setup" "WAN Service", and you will see the WAN Port Information Table in
the screen similar to Figure 4-5, which describes the WAN port settings and the relevant
manipulation to each interface. After you add a new Lay2 Interface, please follow the instructions
below to complete the further configuration of WAN Interface. There are five different
configurations for the connection types, which are PPPoE, IPoE, Bridge, PPPoA, and IPoA. You
can select the corresponding types according to your needs.
Note:
The following section adopts different VPI, VCI to introduce further configuration for the different
connection types, if you need to change the configuration of ATM PVC (VPI/VCI), you should go to
the previous section (4.4.1 Layer2
4.4.2.1 ATM-EoA-PPPoE
If your ISP provides a PPPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
4.4.9 Quality of
Figure 4-4
Figure 4-5
Interface) to configure them again.
19
Service.
(4.4.1.1 ATM Interface).