Detaching The Depth Regulator Unit - Roland EGX-20 User Manual

Detaching the Depth Regulator Unit


Power and View
lights illuminate.

Press the power button to switch off the power.

Open the cover for the carriage.

Screw
Depth regulator unit

When you switch on the EGX-20, a sensor checks whether the depth regulator unit is installed. At this time, the
machine goes into the Engraving mode if the depth regulator unit is install and the 3D Cutting mode if it is not
installed.
If the EGX-20 is switched off, press the power but-
ton to turn it on.
The carriage moves to the right edge and the table moves
to the front, the unit goes into View status, and the Power
and View lights light up.
If the EGX-20 is turned on but the View light is not
illuminated, press the View button.
The carriage moves to the right edge and the table moves
to the front, the unit goes into View status, and the Power
and View lights light up.
Open the cover for the carriage.
The cover for the carriage.
Use the included small hexagonal
wrench to loosen the screw.
When you do this, support the depth regu-
lator unit with your hand to keep it from
falling.
To install the depth regulator unit, pass a pin
through the hole insert the unit as far as it will
go, then tighten the screw.
Store the depth regulator unit in a safe place
to guard against losing it.
4 Creating a Relief (3D Cutting Mode)
Pin
29