IP Touch Bluetooth Wireless handset
1.4
LED
Off: operating normally.
Blinking green: in
communication.
Green steady: handset
charging.
Orange flashing: battery
charge low or handset
outside coverage zone.
Orange steady: malfunction.
If the Bluetooth handset is on its base, you do not need to press the Off-hook/On-
hook key to take or terminate the call. Just off-hook/on-hook the Bluetooth handset.
To install the IP Touch Bluetooth® Handset, refer to chapter: Install the Alcatel-
Lucent IP Touch Bluetooth® Wireless handset. Your Bluetooth® device needs to be
prepared for pairing. Take the handset off the hook and long press on both handset
buttons at the same time. You will hear a 3-note tone and the LED will flash green
and orange. The default PIN code is 0000.
•
Installing or replacing the Bluetooth handset battery
The battery recharges when the Bluetooth handset is on its base.
There is a danger of explosion if the battery is replaced incorrectly - use only the
battery with the reference 3GV28041AB (1.2V 1500 mAh).
Lift up the battery cover
•
Slide out the battery holding part
•
12
Off-hook/On-hook and
Volume/Mute keys
Off-hook/On-hook: press this
key to take or terminate a call
Volume/Mute:
• short successive
presses to change the
handset volume level (3
levels)
• long press to activate
or deactivate mute
mode
Location of the battery