Windshield Washer Fluid - Chevrolet TrailBlazer 2007 Owner's Manual

How to Check Power Steering Fluid
To check the power steering fluid, do the following:
1. Turn the key off and let the engine
compartment cool down.
2. Wipe the cap and the top of the reservoir
clean.
3. Unscrew the cap and wipe the dipstick with
a clean rag.
4. Replace the cap and completely tighten it.
5. Remove the cap again and look at the
fluid level on the dipstick.
For vehicles with the 4.2L L6 engine, the level
should be at the C (Cold) mark. For vehicles with
the 5.3L or 6.0L V8 engines, the level should
be at the FULL mark. If necessary, add only
enough fluid to bring the level up to the mark.
What to Use
To determine what kind of fluid to use, see
Recommended Fluids and Lubricants on page 527.
Always use the proper fluid. Failure to use the
proper fluid can cause leaks and damage hoses
and seals.

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure
to read the manufacturer's instructions before
use. If you will be operating your vehicle in an area
where the temperature may fall below freezing,
use a fluid that has sufficient protection against
freezing.
423