Samsung SRN-470D User Manual page 66

Menu Setup
Motion Detection/Video Analysis Event
You can set target detection region and motion, as well as the alarm signal output.
[MENU]  ▼  <Event>  ►  <Motion Detection/Video Analysis Event>  [ENTER]  ▲▼◄► 
[ENTER]
• Mode : Sets whether to activate motion detection.
In Camera Setup, you should specify each of the motion detection area and sensitivity separately.
• Alarm Out : Sets the alarm output method.
• Alarm Duration : Sets the duration of alarm signal and alarm sound.
M
`
NVR will output the alarm only if the connected network camera is set with the motion detection area and detects a motion
within the area.
Alarm Out Schedule
You can set the conditions and operating hours for scheduled alarms.
[MENU]  ▼  <Event>  ►  <Alarm Out Schedule>  [ENTER]  $%_+  [ENTER]
• Alarm Out : Sets the alarm output method.
`
For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 57)
- <ON> : Marked in green, and always generates alarm on scheduled time.
- <OFF> : Marked in black, no alarm is generated even if an event occurs.
- Event Sync : Marked in orange, generates alarm only when an event occurs.
• Apply to All Alarm out : Applies the configured schedule to all alarms.
M
`
When the alarm is generated on the scheduled time, you can stop the alarm by canceling the schedule.
66_ Menu Setup