Installing/Replacing The Ink Blotter Strips - Kodak i4000 Plus Series User Manual

Installing/Replacing
the ink blotter strips
A-61651 August 2013
The two ink blotter strips, which will be placed in the ink blotter channels at
installation, are located in the scanner transport to collect ink overflow. To
order additional ink blotter strips, see the section entitled, "Supplies and
Consumables" in Chapter 5.
1. Pull the scanner cover release latch forward to release and lift the scanner
cover.
2. Locate the two blotter strip channels. These channels are where the blotter
strips will be installed or replaced.
3. If you are replacing a blotter strip, proceed with Step 4, if not, go to Step 5.
4. Grasp the blotter strip, carefully pull it off of the channel and discard the
soiled strip according to local regulations.
5. Remove the backing from a new blotter strip.
6. Align the blotter strip in one of the channels.
NOTE: Improperly aligned blotter strips may cause document jams.
7. Press the adhesive side of the blotter strip down firmly into the channel.
8. Repeat Steps 4-7 for the other strip.
9. Close the scanner cover.
4-9