Usb/Power Connector Board - HP PAVILION DX6500 Maintenance And Service Manual

USB/power connector board

Description
USB/power connector board
Before removing the USB/power connector board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drives (see
a.
Optical drive (see
b.
Switch cover (see
c.
Keyboard (see
d.
Speaker assembly (see
e.
Display assembly (see
f.
Top cover (see
g.
Remove the USB/power connector board:
Disconnect the USB cable (1) and power connector cable (2) from the system board.
1.
Remove the USB/power connector board cable from the clips (3) built into the base enclosure.
2.
Remove the Phillips PM2.5×5.0 screw (4) that secures the USB/power connector board to the base
3.
enclosure.
Battery on page 36).
Hard drives on page
Optical drive on page
Switch cover on page
Keyboard on page 53)
Speaker assembly on page
Display assembly on page
Top cover on page 61)
41)
47)
49)
51)
55)
Component replacement procedures
Spare part number
449454-001
67