Installation - Alpine INA-W900E Owner's Manual

01GB00INA-W900E.book Page 99 Monday, September 13, 2010 9:52 AM

Installation

Caution
Do not block the unit's fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Air ventilation hole
Rear of the Unit
Caution concerning the installation location
1
Before installing, make sure that the opening and
closing of the display will not interfere with
operation of the gear shift.
Movable Display
2
Angle of installation
Please install this unit as close to horizontal as
possible. Installing the unit beyond the specified
range below, may cause errors during navigation
mode.
0°
Front of the unit
0-30°
Side of the unit
01GB07INA-W900E.fm
3
Air ventilation hole
• If B or C is used, make sure that there is a enough space depthwise
Top of the Unit
10°(±5°)
Top of the unit
*
Remove the mounting sleeve from the main unit (see
"Removal" on page 100).
The unit can be installed in the mounting sleeve in
three positions by aligning its mounting holes (A to
C) on the sides of the unit. Position A will be used in
most cases. If B or C are to be used, the hole
positions need to be modified.
First, determine the mounting position in the
mounting sleeve, then affix the supplied seal (refer
to "How to use a Seal" (page 100)).
Slide the unit into the mounting sleeve and secure it.
before installing the unit. If the unit is forcibly pushed into the
mounting sleeve, damage may occur.
Mounting Sleeve (Included)
Dashboard
This unit
1
Pressure Plates*
<Mounting Hole Position>
Position B
Position A
• Depending on the position chosen, the front panel will protrude
differently.
Front Panel
Dashboard
Position A
Front Panel
Dashboard
Position B
Front Panel
Dashboard
Position C
1
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
ALPINE INA-W900E 68-16909Z25-A (EN)
Seal (Included)
2
Face Plate* (Included)
Position C
99
-EN