Search Function - Alpine INA-W900E Owner's Manual

01GB00INA-W900E.book Page 57 Monday, September 13, 2010 9:52 AM
Adjusting the Balance
B
Touch [L] or [R] to adjust the sound volume of the left
and right speakers.
Setting range: L15 to R15
C Adjusting the Balance/Fader Directly
Touch and move [ ] to a desired setting.
Or touch a desired setting range, and [
location.
Touch [L] or [R] of Balance and [F] or [R] of Fader for fine-tuning.
Adjusting Bass/Treble
You can change the bass/treble frequency emphasis to
create your own tonal preference.
Touch [ ] to display the Bass/Treble adjusting screen.
Touch [ ] or [ ] on the scroll bar to scroll the setup items line
by line.
• Adjustment cannot be performed when an External audio processor
is connected or DEFEAT is set to ON.
Setting the Bass level
You can emphasise or weaken the bass frequency.
Touch [ ] or [ ] of BASS LEVEL to select the desired bass
level.
Setting range: –7 to +7
Setting the Bass Centre Frequency
The displayed bass frequency is emphasized.
Touch [ ] or [ ] of BASS FREQ. to select the desired bass
centre frequency.
Setting range: 60 Hz, 80 Hz, 100 Hz, 200 Hz
Setting the Bass Bandwidth
Changes the boosted bass bandwidth to wide or narrow.
A wider setting will boost a wide range of frequencies
above and below the centre frequency. A narrower
setting will boost only frequencies near the centre
frequency.
Touch [ ] or [ ] of BASS BANDWIDTH to select the desired
bass band width.
Setting range: WIDE1 to WIDE4
• The bass level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, AM, CD, etc.).
Setting the treble level
You can emphasise the treble frequency.
Touch [ ] or [ ] of TREBLE LEVEL to select the desired treble
level.
Setting range: –7 to +7
Setting the Treble Centre Frequency
The displayed treble frequency is emphasised.
Touch [ ] or [ ] of TREBLE FREQ. to select the desired treble
centre frequency.
Setting range:10 kHz, 12.5 kHz, 15 kHz, 17.5 kHz
• The treble level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
01GB05INA-W900E.fm
Setting the Loudness
Loudness introduces a special low- and high-frequency
emphasis at low listening levels. This compensates for
the ear's decreased sensitivity to bass and treble sound.
Touch [ ] or [ ] of LOUDNESS to set to ON or OFF.
• This adjustment cannot be performed when an optional External
audio processor is connected.
] will move to that
Adjusting H.P.F. (Highpass Filter)
Touch [
Touch [ ] or [ ] of the desired speaker.
• Select OFF when no adjustment is required.
• When an external processor or IMPRINT audio processor
(PXA-H100) is connected, the display changes from "H.P.F." to the
"A.PROCESSOR" item. For "A.PROCESSOR" operation, refer to
"External Audio Processor (Optional)" (page 67) or "IMPRINT
Operation (Optional)" (page 73).
Adjusting the Subwoofer Level
Touch [ ] or [ ] of SUBWOOFER to set the subwoofer
ON/OFF.
Touch [
after setting the SUBWOOFER to ON.
Touch [ ] or [ ] to adjust the Subwoofer output.
• When an external processor is connected, the display changes from
"SUBWOOFER" to the "SUBW.LV" item. You can change the
subwoofer output level between 0 and 15 by touching [ ] or [ ].
• The SUBWOOFER SYSTEM, SUBWOOFER PHASE and
SUBWOOFER CHANNEL may be set when an optional IMPRINT
audio processor (PXA-H100) is connected. For details, refer to
"Setting the Subwoofer" on page 76.
Adjusting Nav. Mix Level
Touch [ ] or [ ] of NAV. MIX LEVEL to adjust the
volume of navigation interruption.
Turning Defeat ON or OFF
Touch [
Touch [ ] or [ ] of DEFEAT to set to ON or OFF.
If you set the DEFEAT to ON, MX of the optional External audio
processor is turned OFF and EQ is returned to the initial setting.

Search Function

Touch [
WMA/AAC mode.
Search list screen is displayed.
Select a desired track or folder
] to display the H.P.F. adjusting screen.
Setting range: OFF, 80 Hz, 120 Hz, 160 Hz
] to display the Subwoofer output adjusting screen
Setting range: 0 to 15
Setting range: 0 to 15
] to display the DEFEAT adjusting screen.
] on the function guide while in the CD or MP3/
Touch [ ] for direct playback.
When a hierarchical list is prepared, [
displayed. Touch [ ] to display the respective
hierarchy list screens.
ALPINE INA-W900E 68-16909Z25-A (EN)
] will be
57
-EN