Electrical Requirements - Wolf CSO24 Installation Manual

Convection Steam Oven Specifications

Electrical Requirements

IMPORTANT NOTE: Unless you are using cabinets deeper
than 24" for a standard installation or 25"
(610)
flush inset installation, the electrical supply for the convec-
tion steam oven must be placed in an adjacent cabinet
within reach of the 6'
(1.8 m)
trical location shown in the illustrations on the following
pages that best suits your installation.
IMPORTANT NOTE: You must follow all National Electrical
Code regulations. In addition, be aware of local codes and
ordinances when installing your service.
IMPORTANT NOTE: Performance may be compromised if
the electrical supply is less than 240 volts.
A ground fault circuit interrupter (GFCI) is not recom-
mended and may cause interruption of operation.
Electrical Requirements
Electrical Supply
Service
Receptacle
Power Cord
for a
(635)
power cord. Choose the elec-
240/208 V AC, 60 Hz
20 amp dedicated circuit
NEMA 6-20R grounding-type
6'
ELECTRICAL SHOCK HAZARD: Plug into a grounded
3-prong outlet. Do not remove ground prong. Do not
use an adapter. Failure to follow these instructions can
result in electric shock, fire or death.
To minimize shock hazard, the power cord must be
plugged into a grounding-type receptacle, grounded to
conform with the National Electrical Code, ANSI/NFPA 70
latest edition, or Canadian Electrical Code (CSA) and all
local codes and ordinances. Refer to the illustrations
below.
NEMA
PLUG
(1.8)
GROUNDED
NEMA RECEPTACLE
NEMA 6-20R receptacle.
NEMA
PLUG
3"
(76)
MINIMUM CORD
CLEARANCE
Power cord clearance.
6