NETGEAR CG3100Dv3 User Manual page 21

2. In the main menu, under Advanced, select Wireless Settings.
3. Click the Setup Access List button to display the Wireless Card Access List screen.
Note: If you are configuring the gateway from a wireless computer, make
sure to add your computer's MAC address to the Access List.
Otherwise you will lose your wireless connection when you click
Apply. You must then access the gateway from a wired computer, or
from a wireless computer that is on the access control list, to make
any further changes.
4. In the Network Profiles section, select the radio button for a wireless network.
5. By default the Allow Any radio button is selected. You can either allow computers to
connect to the network based on their MAC addresses, or deny connections based on MAC
address. Select either the Allow List or Deny List radio button.
6. Add devices to the Access List using either of these methods:
• If the computer is in the Connected Wireless Devices table, click its radio button to
capture its MAC address. Then click Add.
• Enter the MAC address of the device in the Add Access Filter fields. The MAC
address can usually be found on the bottom of the wireless device. Then click Add.
7. Click Apply to save these settings.
NETGEAR Wireless Cable Gateway CG3100Dv3
Wireless Configuration
21