Clock And Alarm Mode; Manual Settings - Honeywell TE821W User Manual

CLOCK AND ALARM MODE

MANUAL SETTING
The main unit can be manually set to display the time, calendar or UTC time. There are three time alarms
available on the main unit: Weekday alarm (W), Single alarm (S) and Ice Warning Alarm (Pre-Al).
• If Weekday alarm is activated, it will sound at the set time and the alarm icon will flash Mondays
through Fridays.
• If Single day alarm is activated, it will sound at the set time and the alarm icon will flash only
for this specific day and will not activate on subsequent days.
• The Ice Warning Alarm is activated at programmed time interval (from 15 to 90 minutes)
before the weekday or single alarm, if channel 1 temperature falling to freezing and below.
NOTE: Ice Warning Alarm can be set only if one or both-Weekday or Single alarm are programmed.
The snooze duration for listed alarms can also be programmed up to 15 minutes.
Accessing Clock and Alarm Mode
Press UP or DOWN until the clock icon
Setting the time, date and language
• In the Clock and Alarm Mode, press and hold SET button until the day of week language abbreviation
"ENG" will flash.
• Press the UP or DOWN
Spanish or Dutch.
• Press SET to confirm selection.
• Select the City Code for your area by pressing UP
available codes.
• Press SET to confirm the selection and enter to the latitude and longitude programming mode.
Setting USR latitude & longitude
If you selected the USR as a city code, you will be prompted to enter the latitude, longitude, Time
Zone and select Daylight Savings Time on or off.
• Press UP or DOWN to adjust the latitude. Press and hold down either button for quick digits
advance.
• Press SET to confirm the selection.
• Continue setting the longitude using the same steps.
• Set the Time Zone by pressing UP
and hold down either button for quick digits advance.
• Press SET to confirm selection.
If the USR was selected as a city code or your city is located in the Daylight Savings zone you would
need to set the Daylight Saving Time Option:
• Press UP or DOWN
quick digits advance.
• Press SET to confirm selection.
• Continue setting the year, month, day, calendar format (day/month or month/day), time format
(12 or 24 hours), local hour and minutes, using the same steps.
After programming is complete the display will return to the default Clock and Alarm Mode.
NOTE: Press and hold SET anytime during the setup to return to normal Clock and Alarm Mode. All
previous settings will be cancelled.
next to the time/date display will flash.
selecting the day of the week in English, German, French, Italian,
or DOWN to adjust the time in 30 min intervals. Press
to enable of disable the DST option. Press and hold either button for
17
or DOWN . Refer to P.25 for a list of