Led Backlight Options; Time Alarm Settings - Honeywell TE831W-2 User Manual

If the alert is disabled, "OFF" will be displayed; otherwise the alert value is shown.
When a wind alert is displayed, press UP or DOWN arrow button to activate or deactivate it.
Wind Alert programming
With the wind icon flashing, press ALARM/CHART button to select the desired alarm.
•
• Press and hold ALARM/CHART button until alert and corresponding icon will flash.
• Set the alert using UP or DOWN arrow button. Press and hold either button for fast digits advance.
• Press ALARM/CHART button to confirm your selection and return to the wind alert selection screen.
Disabling the Wind Alert
To disable wind alert when it is displayed after pressing ALARM/CHART button press UP or DOWN arrow button – OFF will
be displayed instead of previously set alarm time.

LED Backlight Options

The main unit backlight can be turned on, off or automatic depending on light conditions. The sensitivity of the backlight sensor
can be adjusted to high or low using the switch, located on the back panel.
Note: For continuous backlight control the AC/DC adaptor must be plugged in.

Time Alarm Settings

There are two time alarms available on the main unit: Weekday alarm (W), and Single alarm (S)
• If Weekday alarm is activated, it will sound at the set time and the alarm icon will flash Monday through Friday.
• If Single day alarm is activated, it will sound at the set time and the alarm icon will flash only for this specific day and
will not activate on subsequent days.
Note: The snooze duration for listed alarms can also be programmed up to 15 minutes
Enable/Disable Time Alarms
• Press the ALARM/CHART button to display the Weekday Alarm or Single Day Alarm time. If these alarms are not set,
the abbreviation OFF will be displayed.
• To enable or disable any of these alarms, press UP or DOWN arrow button
• Press ALARM/CHART button to confirm your setting
Note: Press SET button anytime during alarm programming mode to return to the default clock display.
Programming Time Alarms
With the Clock and Alarm icon flashing, press the ALARM/CHART button to select the desired alarm.
• Press and hold ALARM/CHART button until the hour digit will flash
• Set the alarm hour using UP or DOWN arrow button. Press and hold either button for quick digit advance.
• Press ALARM/CHART to confirm selection.
.
25