Honda BF75A Owner's Manual page 58

5. STARTING THE ENGINE
FUEL HOSE CONNECTOR
2. Connect the fuel hose connector
to the outboard motor. Install the
outboard end fuel hose connector
with the clip toward the outside.
Be sure the fuel hose connector is
securely snapped in place.
If the outboard end fuel hose connec-
tor is forcibly installed in the rever-
sed direction, the fuel hose connector
0-rring seal can be damaged. A
damaged O-ring seal can cause a
fuel leak.
w Gasoline is highly
flammable and explosive, and
you can be burned or ser'iously
injured when handling fuel.
l
Stop engine and keep heat,
sparks, and flame away.
l
Handle fuel only outdoors.
l
Wipe up spills immediately.
OUTLET END
(MOTOR)
PRIMER BULB
3. Hold the primer bulb so that the
outlet end is higher than the inlet
end. The arrow on the primer
bulb points upward. Squeeze the
primer bulb several times until it
feels firm, indicating that fuel has
reached the carburetors. Check
for fuel leaks and repair any leaks
before starting the engine.
Do not squeeze the primer bulb
when the engine is running, because
this could cause the carburetors to
overflow.
56