Table of Contents
Advertisement
Powering On
Apply power by connecting the provided IEC power cord to the rear panel power connector
on the DVC. Connect the DVC to an AC power source.
NOTE:
Default Cycle
When power is applied, the LCD screen displays the Extron S
10 seconds,
version are displayed after approximately another 5 seconds. After those screens, the default
cycle begins, in which the LCD screen alternates every 5 seconds between the input signal
type and data rate, and the output resolution and refresh rate. The default cycle continues
while the menu system is not in use.
The flow diagram below shows the order in which the screens appear at power-up and
during the default cycle.
Power
Figure 10.
Default Cycle — Special Conditions
The default cycle changes when any of the following conditions exist:
•
Audio and video mute settings are not retained when power is cycled to the
DVC.
EXTRON DVC 501 SD
10 sec.
EXTRON
On
DVC 501 SD
5 sec.
60-1033-01
F/W V1.00
5 sec.
INPUT
HDSDI 1.485G
Power-up and Normal Default Cycle Example
No input connected — A single screen is displayed, indicating that there is no input
signal.
INPUT
NO SIGNAL!
Figure 11.
Default Screen When No Input Is Connected
is displayed. The unit part number and current firmware
INPUT
720p @59.94Hz
5 sec.
5 sec.
3
logo. After approximately
DVC 501 SD • Operation
10
Advertisement
Table of Contents
