Setting Up With Wps(Repeater) - D-Link DIR-505 User Manual

Section 2 - Installation
If you are setting the DIR-505 up in Repeater Mode to extend the range of an existing Wi-Fi network and your existing wireless
router has a WPS button, you can use these steps to quickly set up your DIR-505.
1. Move the switch on the top of the DIR-505 to Repeater Mode,
then plug it in within range of your existing Wi-Fi network.
Verify that the power LED has turned green before continuing.
2. Press and hold the WPS button on the side of the DIR-505 for
5 seconds.
Note: You must press the WPS button for at least 5 seconds.
Pressing it for a shorter time activates a diferent WPS mode
which is used to connect wireless devices to the DIR-505.
3. Within 2 minutes, press the WPS button on your existing
wireless router. The DIR-505 will automatically create a
connection to your existing router's Wi-Fi network and will
extend it. You can connect to your extended network by using
the default Wi-Fi network name and password printed on the
Wi-Fi Coniguration Card. To set the DIR-505 to use the same
Wi-Fi network name and number, refer to "Extend Wi-Fi Setup"
on page 102.
D-Link DIR-505 User Manual

Setting Up With WPS(Repeater)

Charger
Router/AP
Repeater
Wi-Fi
Hotspot
16